Library
Library
The component will be designed to the chosen machine specifications
=
Only the selected materials will be considered for the design
=
Number of teeth in the belt
=
12.0
1000.0
Width of the belt
=
0.1
100.0
mm
mm
Limit tension at which the belt should still operate without failure
≥
0.01
100.0
N
N
Smallest beding radius for the belt, at the maximum tension.
≤
2.0
50.0
mm
mm
If true, the belt will be a closed loop. Otherwise a string (printed in spiral form).
=
0.0
1.0
Component mass will not exceed this value
≤
0.0
None
kg
kg
Will work down to min temperature or lower
≤
-273.15
3000.0
°C
°C
Will work up to max temperature or above it
≥
-273.15
3000.0
°C
°C
(a) The author(s) does not warrant the accuracy or the applicability of the results obtained from the use of the Program(s). No other documents or oral conversations, statements or representations will be offered by End User as evidence to explain, expand, alter, add to or invalidate the express warranty set forth above.
(b) The warranty set forth herein is the sole warranty provided to End User and extends only to the End User itself. The author(s) will not be responsible for any breach of warranty caused by (i) modifications (or attempted modifications) to the Program(s) made by or on behalf of End User, (ii) any combination of the Program(s) with any other software, excluding any operating systems for which the Program(s) are licensed to be used, (iii) any use of the Program(s) other than on the Designated Network, or (iv) use of other than the most current release of the Program(s).
(a) IN NO EVENT WILL THE AUTHOR(S) BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL,CONSEQUENTIAL, EXEMPLARY OR PUNITIVE DAMAGES, LOSS OF PRODUCTION, INTERRUPTION OF OPERATIONS, OR LOST DATA OR PROFITS, EVEN IF SUCH DAMAGES WERE FORESEEABLE.
(b) Notwithstanding anything to the contrary in this Agreement, the Author(s) does not limit its liability (if any) to End User for any matter which it would be illegal for Author(s) to exclude or to attempt to exclude its liability, but nothing in this clause confers any right or remedy upon the other party to which it would not otherwise be entitled.
(c) The Program(s) is a mathematical analysis tool intended to assist End User in the development and design processes and requires considerable skill and judgment for its correct use and for the interpretation of the computed results. The Program(s) is not intended to be nor is it a substitute for rigorous and comprehensive prototype or other testing by the End User of products prior to production and sale.
